This is a drawing of an Estop circuit.

http://tech.groups.yahoo.com/group/DynoMotion/files/michaelthomas/

Does this seem like a good way of doing this?

Do I need to notify Kmotioncnc of an Estop condition?

If so.....how would I go about that?

What happens if the usb cable comes unplugged?

Do I need additional safety in case of that event? (like a charge pump).

Thanks,

Mike

Tom.....I really apologize for the basic operation questions. I've searched quite a lot for the answers on the board.

If KFlop loses communication......will the axis' disable?



Thanks,

Mike

--- In DynoMotion@yahoogroups.com, "michaelthomasn" <michaelniksch@...> wrote:
>
> This is a drawing of an Estop circuit.
>
> http://tech.groups.yahoo.com/group/DynoMotion/files/michaelthomas/
>
> Does this seem like a good way of doing this?
>
> Do I need to notify Kmotioncnc of an Estop condition?
>
> If so.....how would I go about that?
>
> What happens if the usb cable comes unplugged?
>
> Do I need additional safety in case of that event? (like a charge pump).
>
> Thanks,
>
> Mike
>